lithium battery 18650 3.7v

　　Precautions for use of sorting equipment

　　1. When starting up, check whether each action actuator of the equipment is in the initial position, confirm that there are no other sundries on the equipment, turn over the air source, confirm that the pressure of the air source is 0.5-0.6mpa, and then run the power control program:

　　2. Turn off the power supply and air source after the equipment stops:

　　3. When repairing, maintaining and maintaining the equipment, the power supply and air source should be turned off:

　　4. When putting the batteries to be divided into the charging box, try to ensure that the positive and negative electrodes of all batteries are in the same direction: when the batteries in the charging box are about to be fully charged, take out the batteries in time:

　　5. When the machine is running, please do not put your hands into the battery sorting track, so as not to hurt your fingers:

　　6. When the equipment runs abnormally or stops for no reason, you should press the emergency stop button first, then check the abnormality of the equipment, and if there is a problem after cleaning, release the emergency stop button to make the manipulator return to the original point, the system pauses, and then press the green button to make the system resume active operations,

　　If the system does not work, you can press the system reset button to resume normal operation.

　　7. When a certain type of battery is sorted and there is no material alarm, press and hold the green button for 3 seconds to start, so that the material is empty. After 30 seconds, the system can actively enter the terminal mode and actively sort the remaining materials into the chute.

　　8. Before each operation of the equipment, the battery of the sorter should be emptied, press the system reset button to make the equipment enter the initial state, and then press the operation button:

　　9. Ensure that the positive and negative terminals of the battery to be sorted are clean, and prevent dust and other debris from contaminating the detection probe to ensure the accuracy of the measurement data:

　　10. In order to ensure the measurement accuracy, it is recommended to clean the probe with alcohol every 4 hours and replace the probe once a month under normal production conditions:

　　11. In order to ensure the high-precision measurement of the instrument, please reset and calibrate the instrument regularly.