button battery 2032

　　Requirements for installation of ship batteries

　　1. Installation of ring lights

　　When vertically installing 2 or 3 signal lights for joint display, the spacing between these lights should not be less than 2 meters, and except for the case of towing lights, the lowest one of the lights should be installed at a height of not less than 4 meters above the ship's hull; When installing three signal lights, the distance between them should be equal.

　　2. Installation of foremast lights:

　　(1) Except for operating signal lights and as described in Rule 8.2.3.1 (4), mast lights should be higher and away from all other lights and obstructions.

　　8.2.3.1 (4): When it is not possible to install the ring lights specified in 8.2.3.11 (operating limit ship lights) and 8.2.3.12 (draft ship lights only) of this chapter at a position lower than the mast lights, these ring lights can be installed above the rear mast lights or hung vertically between the front and rear mast lights. In the latter case, they should be placed at a horizontal distance of not less than 2 meters orthogonal to the centerline of the ship's bow and stern;

　　(2) The height of the foremast lights above the hull should not be less than 6m; If the width of the ship is greater than 6m, the height of the lamp should not be less than the width of the ship, but not necessarily greater than 12m;

　　(3) The foremast lights should be installed on the longitudinal section of the ship; The foremast light should be placed no more than 1/4 of the ship's length from the bow.

　　(4) If only one mast light is equipped, it should be installed at the front of the ship at the same height as the foremast light.

　　3. Installation of Rear Mast Light:

　　(1) Vertical position: The aft mast light should be at least 4.5m higher than the forward mast light. The vertical distance between the front and rear mast lights should be such that, under all normal draft differences, when viewed from a distance of 1000m from the bow of the ship, the rear mast light should be visible above the front mast light and separated.

　　(2) Horizontal position: The aft mast light should be installed on the longitudinal section of the ship. The horizontal distance between the front and rear mast lights should not be less than 1/2 of the ship's length, but not more than 100m.

　　4. Installation of ganglights:

　　(1) Vertical position: The height of the motor ship's side lights above the hull should not exceed 3/4 of the height of the foremast lights, but should not be so low as to be disturbed by deck lights;

　　(2) Horizontal position: The ganglights of motor boats should not be installed in front of the foremast lights and should be installed on or near the side of the ship; The ganglights of the pushed ship should be installed at the front end of the ship.

　　(3) The cover plate of the side light: The side light should be equipped with a matte black inner cover plate and should comply with the requirements of 8.2.1.4 of this section.

Read recommendations:

603450 1200mAh 3.7V

48V lithium ion battery

Environmental Friendliness of Cylindrical Lithium - Ion Batteries

801620 battery Manufacturing

18650 li ion rechargeable battery