button battery cr2032.Battery management system failure analysis methods and cases

　　The battery management system (BATTERYMANAGEMENTSYSTEM), commonly known as the battery nanny or battery steward, is an important link between vehicle power batteries and electric vehicles. Its main functions include: real-time monitoring of battery physical parameters; battery status estimation; online diagnosis and early warning; charging, discharging and Precharge control; equalization management and thermal management, etc. The main purpose of the battery management system (BMS) is to improve battery utilization, prevent battery overcharge and overdischarge, extend battery life, and monitor battery status.

　　The battery management system is not only closely related to the battery, but also has various connections with the vehicle system. Among all faults, compared with other systems, the battery management system faults are relatively high and difficult to deal with. The editor has summarized some common methods for dealing with battery management system failures and case studies of common battery management system failures for reference by relevant personnel of vehicle, battery, and management system manufacturers.

　　BMS fault analysis method

　　Observation

　　When communication interruption or control abnormality occurs in the system, observe whether there are alarms in each module of the system and whether there are alarm icons on the display screen, and then investigate the resulting phenomena one by one.

　　Fault Reproduction Method

　　Vehicle faults occur under different conditions. If conditions permit, try to reproduce the fault under the same conditions as much as possible to confirm the problem point.

　　Exclusion

　　When similar interference occurs in the system, each component in the system should be removed one by one to determine which part is causing the impact on the system.

　　substitution method

　　When a module has temperature, voltage, control, etc. abnormalities, swap the positions of modules with the same number of strings to diagnose whether it is a module problem or a wiring harness problem.

　　Environmental Inspection Act

　　When a system failure occurs, such as the system cannot be displayed, we should not rush to consider it in depth because we often overlook some details. First we should look at the obvious things: Is the power plugged in? Is the switch turned on? Are all the wiring connected? Maybe that's where the problem lies.

　　program upgrade method

　　When an unknown fault occurs after a new program is burned, causing system control abnormalities, the previous version of the program can be burned for comparison to analyze and handle the fault.

　　data analysis

　　When a control or related failure occurs in the BMS, the data stored in the BMS can be analyzed, and the content of the messages in the CAN bus can be analyzed.

Read recommendations:

602248 600mAh 3.7V

Super Capacitor Battery

Analysis of User Feedback on Polymer Batteries

521133 battery Vendor

AA NiMH battery