r03 battery.Waste battery refurbishment technology

　　Used battery refurbishment technology provided to you by electronic enthusiasts. Used battery refurbishment technology. 80% of the causes of failure of scrapped batteries encountered in daily life are waste battery refurbishment technology. 80% of the scrapped batteries encountered in daily life fail. The cause is caused by the vulcanization of the battery plates. This part can be repaired with our battery pulse repair equipment. So are the remaining 20% of scrap batteries with structural damage impossible to save? the answer is negative!

　　For batteries with structural damage that cannot be repaired with battery non-destructive repair equipment, our company can provide a complete set of battery refurbishment technologies, including battery cover opening, single-cell plate capacity detection technology, plate replacement, shell replacement, and pole posts. Repair, plate welding, broken grid perforation repair and shell bonding and other series of technologies.

　　The method is: using our company's original single-cell capacity detection technology, multiple batteries with internal short circuits or broken cells are tested for single-cell capacity, and the capacity of each single cell is accurately detected, and then single-cell batteries with similar capacities are reassembled. into a new battery casing, there is no need to purchase new plates, which greatly reduces the number of scrapped batteries and quickly restores the battery to like new.

　　The benefits of refurbishing used batteries are obvious. Take a 12V12AH battery as an example. The purchase price of used batteries is about more than 30 yuan. After refurbishing, it can be sold for 80 to 110 yuan, with a profit margin of 50 to 80 yuan. For For a 48-volt electric vehicle, the profit from a set of refurbished batteries can reach 200 to 320 yuan.

　　Waste battery refurbishment process and tool configuration:

　　●Battery opening, welding and sealing process ●Battery single cell capacity detection technology

　　●All-in-one battery opening and welding machine ●10/12AH battery welding mold

　　●17/20AH battery welding mold ●Battery post welding mold

　　The flow chart of used battery refurbishment is as follows: Repair the battery, test the capacity, open the battery cover, take out the qualified plates, install the new shell, before welding, after welding, sealing and capping

Read recommendations:

Coin Battery CR 1620

How to avoid phone battery explosion?

Shaped Batteries in Electronic Gifts

connector for energy storage battery Processing

CR2354 battery