6LR61 alkaline battery

　　How to maintain 6LR61 alkaline battery and install them?

　　The temperature of the UPS battery should not be lower than -20℃ and exceed +40℃. It should be stored in a dry, low-temperature and well-ventilated place. In addition, when installing the UPS battery, first check whether the packaging is intact. When inputting the power cord, connect the UPS battery to the mains. , start charging the battery. Next, I will introduce the detailed content to you.

　　1. How to maintain 6LR61 alkaline battery

　　1. When storing, please be careful that the temperature does not fall below -20℃ and exceed the range of +40℃.

　　2. When storing the battery, the battery must be stored in a fully charged state. Since part of the capacity will be lost due to self-discharge during transportation or during storage, please replenish the battery at any time during use to avoid capacity reduction of the UPS battery caused by long-term automatic discharge.

　　3. When storing for a long time, in order to make up for the self-discharge during storage, please perform supplementary charging.

　　4. Storage under conditions exceeding 40C will have a great impact on battery life. Please avoid it if possible.

　　5. Please store it in a dry, low-temperature, and well-ventilated place.

　　6. If the battery packaging is accidentally wetted by water during storage or transfer, the packaging carton should be removed immediately to prevent the wet carton from becoming a conductor and causing the battery to discharge or burn out the positive terminal (because water is conductive) .

　　7. Check the battery regularly. If dust or other external contamination is found, please clean it with a cloth soaked in water or warm water. Do not use organic solvents or oils such as gasoline and banana water for cleaning (to avoid corrosion to the UPS battery packaging structure), and avoid using chemical fiber cloth.

　　8. During float charging, if the total voltage during battery charging or the index value of the voltmeter on the indicator plate deviates from the reference value shown in the table below (±0.05V/single cell), the cause should be investigated and dealt with.

　　2. Installation of ups battery

　　1. Packaging inspection

　　Open the packaging box, and inside it should be: USP battery and instructions. Remove the USP battery and check if it was damaged in transportation. If there is any damage or parts missing, do not turn on the machine and notify the carrier or dealer. Connect the battery. Connect the red wire of the battery connection on the back panel of the USP battery to the positive terminal of the battery, and the black wire of the battery connection to the negative terminal of the battery.

　　2. Mains power connection

　　When the input power cord connects the usp battery to the mains, start charging the battery. It is recommended to charge for 6 hours before use. To connect the device, use the device's input power cord to connect to the regulated battery output socket on the back panel of the USP battery.

　　3. Turn on usp battery

　　When turning on the usp battery, lightly press the switch button and the indicator light will light up. The usp battery has a DC start-up function, which can directly start the UPS without the need for mains power, which is convenient to use. Once the mains power is interrupted and the UPS switches to backup power supply, please promptly save other loads on the personal computer or perform other power outage emergency measures. After the mains power is restored, please turn on the usp in time to charge the battery. turn off usp battery

Read recommendations:

801752 720mAh 3.7V

Advantages and disadvantages of ternary lithium battery

powerwall lifepo4 battery for solar system.New breakthrough in ternary lithium batteries - magazine

801520 battery manufacture

602030 polymer battery